Polaris 280 User Manual download pdf (Page 5)

Assemble the Cleaner

1. Use the nut to attach the feed hose to

the feed pipe.

. Pull out the bag and attach the bag

collar to the feed hose.

3. Position the head float 1/2 to 1 inch

back from feed pipe.

4. Turn on the pool filtration pump and

allow it to prime before turning on the

booster pump.

Check for Proper RPM

Before operating the Polaris, check for proper wheel revolutions per minute (RPM). For

maximum efficiency, the Polaris should operate between 28 and 32 RPM.

Mark the single-wheel

side tire.

2. Turn pump on, hold cleaner

below water level and count

wheel revolutions for 1 minute.

If count is

less than 28 RPM:

• Check the filter screen in the

in-line filter for debris that restricts

water flow.

• Clean the skimmer, filter and pump basket, clearing

debris that restricts water flow.

• Check the hoses, connections and swivels for leaks that cause

loss of water pressure.

• Remove the blue restrictor disk from the UWF.

• If an adjustable gate valve is installed on the booster pump or cleaner line, open it

completely so water can flow freely to the Polaris.

If count is

more than 32 RPM:

•

Replace the blue restrictor disk in the UWF with the red restrictor. If the flow is still too

high, unscre

w the pressure relief v

alv

e until the proper RPM is reached.

Note: The

pressure relief valve should only be adjusted when a restrictor is installed.

• If an adjustable valve is installed after the booster pump, adjust it to reduce the water

flow to the cleaner.

www.polarispool.com

Bag Collar

Filter Bag

Feed Hose

Hose Nut

Feed Pipe

Head

Float

Single-wheel side

Sweep Hose

English

1 2 3 4 5 6 7 8 9 10 ... 63 64

Comments to this Manuals

No comments

Polaris 280 User Manual Page 5

Comments to this Manuals

Related products and manuals for Water equipment Polaris 280