Polaris 340 User Manual download pdf (Page 6)

Adjust Suction Hose to Fit Pool Length

With the hose attached to the pool, extend the hose to the farthest point of the pool. The

hose end should reach 2 to 3 hose sections past the farthest point.

Hose too long? Remo

ve excess hose sections from the middle of the hose.

Hose too short? Buy additional standard hose sections.

After adjusting the hose length, position the hose weights as shown.

Note: For pools less than 5 feet deep, remove weight from leader hose and position weight

on standard hose four feet from Polaris.

Test and Adjust Water Flow

For proper operation, the Polaris 340 must receive the correct amount of water flow. Check

the pool’s available water flow with the flow indicator.

1. Detach hose and flow regulator, if used. Fill hose completely with water. Reattach flow

regulator and hose.

2. Connect flow indicator to the leader hose.

3. Holding flow indicator underwater, turn on the pump.

4. The target area on the flow indicator represents the correct water flow range.

too little flow:

• Verify that pool filter and pump basket are clean.

•

erify that all suction lines are closed except the one utilized by the flow indicator.

•

Chec

k hose cuffs and connections f

or leaks that cause loss of flow.

• For dedicated suction line installations, adjust valve in equipment area that controls

water flow to suction line until indicator is within the target area. Mark valves for

ref

erence.

www.polarispool.com



Too

Little

Flow

Too

Much

Flow

Target

Area

English

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

No comments

Polaris 340 User Manual Page 6