Polaris 600 HO RMK 155 User Manual download pdf (Page 107)

104

MAINTENANCE

n Track Alignment

Periodically check that the track is

centered and running evenly on the

slide rails. Misalignment will cause

excessive wear to the track and slide

rail.

1. Safely support the rear of the

snowmobile with the track off the

ground.

2. Start the engine and apply a small

amount of throttle until the track

turns slowly at least five com-

plete revolutions. Stop the engine

and let the track come to a stop

(do not apply brakes).

3. Inspect track alignment by looking through the track window to

make sure the rails are evenly spaced on each side. If the track runs

to the left, loosen the left locknut and tighten the left adjusting bolt.

If the track runs to the right, loosen the right locknut and tighten the

right adjusting bolt.

4. After adjustments are complete, tighten the locknuts and torque

idler shaft bolts to 35 ft. lbs. (47.5 Nm).

5. Repeat steps 2 and 3 to verify proper alignment.

Rail

Window

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 134 135

No comments

Polaris 600 HO RMK 155 User Manual Page 107